How should a leaking roof be repaired?
Roof leaks usually come from an ageing membrane, cracks, failed details at drains and pipe penetrations, or ponding caused by poor falls. Grand Engineering first surveys the roof and locates the leak, decides whether local repair or full re-membraning is appropriate, and then issues a written quotation listing the method, materials and programme. Completed work is verified with a ponding test and handed over with a photo record.
Common signs
- Water stains, blistering paint or spalling on the top-floor ceiling
- Dripping after rain, or persistent mould at wall corners
- Cracks on the roof slab, or a blistered or damaged membrane
- Standing water around drains
- Leaks around water tank or air-conditioner plinths
Method statement
- Site survey and leak tracingMeasure, photograph and inspect the membrane, cracks, drains and penetrations, using infrared thermography where useful.
- Remove old membrane and debrisStrip blistered or failed membrane as required and clean the substrate until dry.
- Substrate repairRepair cracks, hollows and spalling, and adjust falls to reduce ponding.
- Detail reinforcementAdd reinforcement layers at internal corners, drains, pipe penetrations and upstands.
- PrimerImprove the bond between membrane and substrate.
- Membrane installationApply or lay the membrane to the specified thickness and number of coats.
- Ponding testPlug the drains and hold water to confirm no leakage below before the next stage.
- Protection or top coatInstall a screed, reflective top coat or wearing layer to suit use, then clear the site.
Systems and materials
| System | Typical use |
|---|---|
| Polyurethane (PU) liquid membrane | Roofs with complex shapes and many penetrations; seamless finish |
| Cementitious waterproof coating | Areas to be tiled or rendered afterwards, and damp substrates |
| Sheet membrane | Large, flat roof areas |
| Reflective heat-insulating top coat | Exposed roofs, to reduce sun damage to the membrane |
We commonly use Nippon and Sika products. The final system depends on site conditions, use and budget, and is stated in the quotation.
Testing and records
- Ponding test; duration stated in the quotation
- Photo record of key stages
- Maintenance advice on completion
- Warranty typically 3–10 years, stated in the quotation according to system and scope
Information we need for a quote
- Building address and age
- Approximate roof area
- Photos or videos of the leak
- Whether the roof is a common area (owners' corporation or management approval required)
FAQ
Does a leaking roof always need full re-waterproofing?
Not always. If the membrane is largely sound and only isolated cracks or drains have failed, local repair may be enough. If the membrane is generally aged, blistered or leaking in many places, full re-membraning is usually more cost-effective. A site survey is needed to decide.
Who arranges repairs to a common roof?
A common roof is usually handled by the owners' corporation or management company. If the roof belongs to an individual owner, the owner can appoint a contractor directly. We can provide quotations and documents for owners' corporations.
Can waterproofing be done in the rain?
Most waterproofing materials must be applied to a dry substrate. Work pauses in rain or when the surface is damp, and the programme is adjusted for weather.
How is the result verified?
With a ponding test: the drains are plugged and water is held on the roof for a set period while the ceiling below is checked. Protection layers are installed only after the test passes.
How long is the warranty for roof and flat-roof waterproofing?
Our warranty for roof and flat-roof waterproofing is typically 3–10 years. The exact period depends on the system, materials and scope, and the warranty terms are stated in the quotation.







